ChimneySaver Water Repellent

ChimneySaver Water Repellent
In stock

According to the Brick Industry Association, chimneys require special attention and maintenance to prevent costly damage caused by water penetration. Because chimneys project above the roof line, they are vulnerable to the elements. Nearly every chimney you encounter has signs of water damage! The first step is to determine the cause and then find the best corrective measures. ChimneySaver, the first chimney water repellent developed specifically for chimneys, has been used successfully by leading chimney professionals for nearly 20 years. Chimney Saver reduces water penetration into the masonry by 99.9%, according to ASTM tests conducted at the University of Wyoming.

Chimney Saver is also 100% vapor permeable, which means it won’t trap water vapors that may pass through the bricks when the chimney is in use, unlike other products found in most hardware or home improvement stores. When applied to a masonry chimney, those products can actually slow down water vapors as they pass through the chimney, which leads to water damage.

Whether to use Water-Base or Solvent-base

Chimney Saver is available in both solvent (mineral spirits) and water-based formulas. The water-based formula is the most popular; however, if chimney water repellent has previously been applied to the masonry, we recommend the solvent-based formula.

Moisture from a variety of sources is always present in masonry and concrete. Sealers and silicone coatings form a water resistant surface film which trap water vapors inside. If these vapors cannot escape, they will contribute to spalling, scaling, deterioration, and freeze-thaw damage. ChimneySaver is a 100% vapor permeable, non-film-forming chimney water repellent that penetrates and lines masonry pores.

•10 Year Warranty

•100% Vapor Permeable

•Non-Glossy Look

•Efflorescence/Stain Protection

•Mildew/Fungus Resistant

•Freeze/Thaw Protection

•Water-Based and Environmentally Friendly

•Dries Clear

  •  Coverage Rate: Approx. 90-150 sq. ft. per gallon
  •   Available Sizes: 3, 5 and 30 gallon containers
  •   Application Temperatures: Minimum 40° F
  •   Application Method: Pump Sprayer
  •   Dry Time: 1-2 hours (allow 6 hours before rainfall)
  •   Cleanup: Soap and water while product is still wet – be sure to remove overspray from     non-target surfaces (especially windows/glass) before product dries